IBM 8678 Installation And User Manual page 44

Note: After you replace the battery, you must reconfigure your blade server and
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
30
BladeCenter HS20 Type 8678: Installation and User's Guide
reset the system date and time.
1. Review the information in "Safety" beginning on page v and "Installation
guidelines" on page 15.
2. Follow any special handling and installation instructions supplied with the
battery.
3. Turn off the blade server and remove the blade from the BladeCenter unit (see
"Removing the blade server from the BladeCenter unit" on page 16 for
instructions).
4. Open the blade server cover (see "Opening the blade server cover" on
page 17 for instructions).
5. Locate the battery on the system board.
Battery
6. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.