Sony PXW-X400KF Operating Instructions Manual page 62

000 62
5. Network Configuration: Connecting Devices using Wireless LAN
[Note]
It may take some time (30 seconds to 1 minute) to enable
station mode. Wait until the network indicator (page 17)
signal strength icon stops flashing on the LCD monitor or in
the viewfinder.
5
Select Maintenance >Network >WPS in the
setup menu.
6
Turn the MENU knob to select [Execute], then
press the knob.
7
Press the access point WPS button.
For details about WPS button operation, refer
to the instruction manual for the access point.
When the connection is successful, the
network indicator (page 17) signal strength
icon will show a strength of 1 or higher on the
LCD monitor or in the viewfinder.
[Note]
If the connection fails, perform the procedure again from
1
step .
8
Connect the device to the access point.
For details about how to connect, refer to the
instruction manual for each device.