Sony PXW-X400KF Operating Instructions Manual page 4

000 4
1. Overview: Name and Function of Parts
Accessory Attachments
1
9
10
11
1.
Wireless receiver insertion slot (page 28)
"Attaching a Wireless Receiver" (page 28)
2.
Shoulder strap fitting (page 29)
3.
Accessory shoe (page 29)
4.
Viewfinder front-to-back positioning lever
(page 24)
5.
Viewfinder left-to-right positioning ring
(page 23)
6.
Viewfinder attachment shoe (page 23)
2 3 4 5
12 13 14 15 16 17 18 19
7.
VF (viewfinder) connectors (26-pin,
rectangular and 20-pin, round)
The analog interface connector (20-pin) is for
connection of an HDVF series viewfinder, and
the digital interface connector (26-pin) is for
connection of a CBK-VF02 HD viewfinder.
Connect a viewfinder connection cable to the
connector compatible with the viewfinder being
used.
[Notes]
ˎ Do not connect viewfinders to both connectors at the ˎ
same time.
ˎ When connecting or disconnecting an interface cable to ˎ
this connector, power off the camcorder first.
8.
Lens mount securing rubber
After locking the lens in position using the lens
locking lever, fit this rubber over the lower of
the two projections. This fixes the lens mount,
preventing it from coming loose.
9.
Viewfinder front-to-back positioning knob
(page 23)
10.
Attachment for optional microphone holder
(page 28)
11.
LIGHT (video light) connector (2-pin, female)
6 (page 29)
12.
Shoulder pad (page 29)
7
13.
Lens cable clamp
8
Clamps the lens cable.
14.
MIC IN (microphone input) (+48 V) connector
(XLR type, 5-pin, female)
Connect a stereo microphone to this connector.
The power (+48 V) is supplied via this connector.
15.
LENS connector (12-pin) (page 26)
[Note]
When connecting or disconnecting the lens cable to this
connector, power off the camcorder first.
16.
Tripod mount
When using the camcorder on a tripod, attach the
tripod adaptor (optional).
17.
Lens mount (special bayonet mount)
(page 26)
18.
Lens locking lever (page 26)
19.
Lens mount cap
Remove by pushing the lens locking lever up.
When no lens is mounted, keep this cap fitted for
protection from dust.
Controls Near the Lens
1
2
1.
REC START (recording start) button
Press to start recording. Press it again to stop
recording. The operation is the same as that of the
VTR button on the lens.
2.
SHUTTER switch
Set to ON to use the electronic shutter. Push to
SELECT to switch the shutter speed or shutter
mode setting. When this switch is operated, the
new setting appears on the viewfinder screen for
about three seconds.
"Setting the Electronic Shutter" (page 39)
3
4
5
6