Table of Contents
Advertisement
10 Checking the Saw
2
► Use a STIHL filing gauge (2) to check the
height of the depth gauges (1). The STIHL fil‐
ing gauge must match the chain pitch.
► If a depth gauge (1) projects from the filing
gauge (2): Lower the depth gauge (1),
2
4
► Make sure the service marks (1 to 4) on the
cutters are visible.
► If one of the service marks is not visible on a
cutter: Do not use your chainsaw and contact
your STIHL servicing dealer for assistance.
► Use a STIHL filing gauge to check that a filing
angle of 30° has been maintained on all cut‐
ters. The STIHL filing gauge must match the
chain pitch.
► If a filing angle of 30° has not been main‐
tained: Resharpen the saw chain.
► If you have any queries: Contact your STIHL
servicing dealer for assistance.
10.4
Testing the Chain Brake
► Shut off the engine and engage the chain
brake.
WARNING
■ The chain's cutters are very sharp. There is a
risk of cut injuries.
► Wear work gloves made of durable mate‐
rial.
► Try to pull the chain along the guide bar by
hand.
If the chain cannot be pulled along the bar by
hand, the chain brake is functioning.
► If the chain can be pulled along the bar by
hand: Do not use your chainsaw and contact
your STIHL servicing dealer for assistance.
0458-784-0121-C
1
16.3.
1
3
The chain brake is defective.
10.5
Checking the Controls
Throttle trigger lockout and throttle trigger
► Shut off the engine and engage the chain
brake.
► Attempt to pull the trigger without depressing
the lockout lever.
► If the trigger can be pulled: Do not use your
chainsaw and contact your STIHL servicing
dealer for assistance.
There is a malfunction in the throttle trigger
lockout.
► Press down the throttle trigger lockout and
hold it there.
► Pull the throttle trigger and release it again.
► If the throttle trigger is stiff or does not spring
back to its idle position: Do not use your chain‐
saw and contact your STIHL servicing dealer
for assistance.
The throttle trigger is defective.
Stopping the engine
► Start the engine.
► Move the Master Control lever to position
The engine stops and the Master Control lever
springs back to position .
► If the engine does not stop:
► Move the Master Control lever to posi‐
tion
.
The engine stops.
► Do not use your chainsaw and contact your
STIHL servicing dealer for assistance.
The Master Control lever is defective.
10.6
Checking Chain Lubrication
► Start the engine and disengage the chain
brake.
► Hold the guide bar over a light surface.
► Open the throttle.
Chain oil is thrown off the chain and is visible
on the light surface. Chain lubrication is oper‐
ating properly.
► If no chain oil can be seen:
► Shut off the engine.
► Fill up with chain oil.
► Check chain lubrication again.
► If chain oil is still not visible on the light sur‐
face: Do not use your chainsaw and contact
your STIHL servicing dealer for assistance.
Chain lubrication is defective.
English
.
17
Advertisement
Table of Contents
