Table of Contents
Advertisement
The exact arrangement you use to interconnect various video and audio components to the unit is dependent
on the model and features of each component. Check the Owner's Manual provided with each component for
the location of video and audio inputs and outputs.
Using an Audio Amplifier
Audio (L) Output
Audio (R) Output
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with a built-in digital surround sound as follows, you can enjoy the various audio
systems including Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, MPEG decoder or etc as
shown below.
Rear of the unit
Coaxial Digital
Audio Output
Coaxial digital cord
(not supplied)
To Coaxial Digital
Audio Input
AV Amplifier with built-in digital surround
decoder as listed above
*
Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby
Laboratories.
*
"DTS" and "DTS Digital Out" are trademarks of Digital Theater Systems, Inc.
NOTES:
•
When you make the connections above, do not set DOLBY DIGITAL to DOLBY DIGITAL, MPEG to MPEG to ON
on the AV Amplifier. If you do, a loud noise will suddenly come out from the speakers, affecting your ears or
causing the speakers to be damaged.
•
Some DTS decoders which do not support DVD-DTS interface may not work properly with the unit.
Connections to other equipment
Rear of the unit
AUDIO cord (not supplied)
Amplifier
To Audio (R) Input
Front
Speaker
(Left)
Surround
Speaker (Left)
To Audio (L) Input
Subwoofer
Unit
Center Speaker
Front
Speaker
(Right)
Surround
Speaker
(Right)
13
Advertisement
Table of Contents
