Rack Mounting - Panasonic WJ-HD716K Installation Manual

Rack mounting

Install the recorder in an EIA standard rack.
Equivalent to EIA standard rack (not manufactured by Panasonic): EIA 19-inch rack type (Depth: 550 mm or more)
Note:
• Use four M5 x 12 screws (locally procured) to install the recorder in a rack.
Step 1
Remove the five rubber feet from the bottom of the recorder
using a flathead screwdriver.
Use a screwdriver to remove the screws holding the rubber
feet.
Step 2
Attach the rack handles to the rack mount brackets.
Fix them firmly using the screws for the rack handle (x4) and
the washers (x4).
Washer
28
Remove the rubber feet.
Screw for rack handle
Rack mount bracket
Washer
Rack handle
Step 3
Place the rack mount brackets on both sides of the recorder.
Fix them firmly with the rack mount bracket fixing screws
(x6).
Screw for rack mount bracket (provided)
Rack handle
Rack mount bracket (provided)
Step 4
Install the recorder in the rack.
Fix them firmly using the rack mount screws.
Rack mount screws
M5 x 12 (locally procured)
Important:
• Keep the temperature in the rack below +45 °C
{+113 °F}.
• It is recommended to install cooling fans or equivalents
to keep the temperature in the rack below +30 °C
{+86 °F}.
• When installing the recorder in the rack, make a space of
1U (44 mm {1-23/32"}) above and below the recorder
for ventilation.
• Do not block the ventilation openings or slots to prevent
the recorder from overheating.
Rack handle