Stamina X 20-3011A Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 7
Refer to the inset drawing. Attach the PAD MOUNTING FRAME(8) to the HYPER EXTENSION POST(7)
with HEX BOLTS(M8x1.25x55mm)(29), WASHERS(M8)(32), and NYLOCK NUTS(M8x1.25)(34). Attach
the HYPER EXTENSION PAD(12) to the PAD MOUNTING FRAME(8) with HEX BOLTS(M8x1.25x35mm)
(30) and WASHERS(M8)(32).
STEP 8
Refer to the illustration below. Attach the SQUAT CUSHION(11) to the SQUAT CUSHION FRAME(9) with
HEX BOLTS(M8x1.25x55mm)(29) and WASHERS(M8)(32). Insert the SQUAT CUSHION FRAME(9) into
the MAIN FRAME(3) and lock it in place with the ADJUSTMENT KNOB(15) and SECURING KNOB(35).
The pin of the ADJUSTMENT KNOB(15) must be inserted into one of the adjustment holes in the SQUAT
CUSHION FRAME(9) and the ADJUSTMENT KNOB(15) and SECURING KNOB(35) must be screwed in
tight to ensure that the SQUAT CUSHION FRAME(9) will fit securely in the MAIN FRAME(3).
NOTE: You can choose to install the HYPER EXTENSION PAD(12) to the MAIN FRAME(3), loosen but do
not remove the SECURING KNOB(35). Loosen and pull the ADJUSTMENT KNOB(15), then insert
the HYPER EXTENSION POST(7) into the MAIN FRAME(3) and secure with the ADJUSTMENT
KNOB(15). Tighten the ADJUSTMENT KNOB(15) and SECURING KNOB(35).
8
34
32
32
30
12
32
29
7
32
29
32
29
35
3
11
11
9
15