Parksense Sensors; Parksense Warning Display; Parksense Display - Dodge Charger SRT Hellcat 392 2016 Owner's Manual

ParkSense can be active only when the gear selector is in
REVERSE. If ParkSense is enabled at this gear selector
position, the system will remain active until the vehicle
speed is increased to approximately 7 mph (11 km/h) or
above. The system will become active again if the vehicle
speed is decreased to speeds less than approximately
6 mph (9 km/h).

ParkSense Sensors

The four ParkSense sensors, located in the rear fascia/
bumper, monitor the area behind the vehicle that is
within the sensors' field of view. The sensors can detect
obstacles from approximately 12 inches (30 cm) up to 79
inches (200 cm) from the rear fascia/bumper in the
horizontal direction, depending on the location, type and
orientation of the obstacle.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 211

ParkSense Warning Display

The ParkSense Warning screen will only be displayed if
Sound and Display is selected from the Uconnect System.
Refer to Uconnect Settings" in "Understanding Your
Instrument Panel" for further information.
The ParkSense Warning screen is located within the
Driver Information Display (DID). It provides visual
warnings to indicate the distance between the rear
fascia/bumper and the detected obstacle. Refer to
"Driver Information Display (DID)" in "Understanding
Your Instrument Panel" for further information.

ParkSense Display

When the vehicle is in REVERSE and an obstacle has
been detected, the warning display will turn on indicat-
ing the system status.
3