Table of Contents
Advertisement
132
STARTING AND OPERATING
The ignition must be in the ON/RUN mode for a
shift to take place and for the position indicator
lights to be operable. If the ignition is not in the
ON/RUN mode, the shift will not take place and no
position indicator lights will be on or flashing.
A flashing N (Neutral) position indicator light indi-
cates that shift requirements have not been met.
6.
Using a ballpoint pen or similar object, push and hold
the recessed transfer case N (Neutral) button
(located by the selector switch) for one second.
N (Neutral) Button
7.
When the N (Neutral) indicator light turns off, release
the N (Neutral) button.
8.
After the N (Neutral) button has been released, the
transfer case will shift to the position indicated by the
selector switch.
9.
Shift the transmission into PARK and turn the
engine off.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into REVERSE or DRIVE,
release the brake pedal, and check that the vehicle
operates normally.
DRIVING TIPS
O
-R
D
T
N
OAD
RIVING
IPS
Utility vehicles have higher ground clearance and a
narrower track to make them capable of performing in a
wide variety of off-road applications. Specific design
characteristics give them a higher center of gravity than
conventional passenger cars.
An advantage of the higher ground clearance is a better
view of the road, allowing you to anticipate problems. They
are not designed for cornering at the same speeds as
conventional passenger cars any more than sports cars
are designed to perform satisfactorily in off-road
conditions. Avoid sharp turns or abrupt maneuvers. As
with other vehicles of this type, failure to operate this
vehicle correctly may result in loss of control or vehicle
rollover.
O
-R
D
T
FF
OAD
RIVING
IPS
When To Use 4WD Low — If Equipped
When off-road driving, shift to 4WD Low for additional
traction. This range should be limited to extreme
situations such as deep snow, mud, or sand where
additional low speed pulling power is needed. Vehicle
speeds in excess of 25 mph (40 km/h) should be avoided
when in 4WD Low.
WARNING!
Do not drive in 4WD Low on dry pavement; driveline
damage may result. 4WD Low locks front and rear
drivelines together and does not allow for differential
action between the front to rear driveshafts. Driving in
4WD Low on pavement will cause driveline binding; use
only on wet or slippery surfaces.
Driving Through Water
Although your vehicle is capable of driving through water,
there are a number of precautions that must be
considered before entering the water.
CAUTION!
When driving through water, do not exceed 5 mph
(8 km/h). Always check water depth before entering as
a precaution, and check all fluids afterward. Driving
through water may cause damage not covered by the
New Vehicle Limited Warranty.
Driving through water more than a few inches/
centimeters deep will require extra caution to ensure
safety and prevent damage to your vehicle. If you must
drive through water, try to determine the depth and the
bottom condition (and location of any obstacles) prior to
entering. Proceed with caution and maintain a steady
controlled speed less than 5 mph (8 km/h) in deep water
to minimize wave effects.
Advertisement
Table of Contents
