Installing The Mower; Servicing The Fuse - Toro 14-38Z Operator's Manual

m–6431
Figure 45
1. Hairpin cotter and clevis
pin
5. Remove the hairpin cotter and washer from the
adjusting rod (Fig. 46) on each side of the mower.
6. Remove the hairpin cotter and washer at the mower
leveling brackets (Fig. 46) on each side of the mower.
Note which hole the leveling bracket is mounted in for
future installation. Slide the brackets off of the
mounting pin.
1
2
Figure 46
1. Leveling bracket—38 inch
model shown
7. Slide the mower rearward to remove the mower belt
from the engine pulley.
8. Slide the mower out from underneath the tractor.
Note: Retain all parts for future installation.

Installing the Mower

1. Park the machine on a level surface and disengage the
blade control (PTO).
2
1
2. Support rod
2
3
m–6432
2. Hairpin cotter and washer
3. Adjusting rod
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Slide the mower under the tractor.
4. Lower the height-of-cut lever to the lowest position.
5. Attach the adjusting rod to the tractor with the washer
and hairpin cotter (Fig. 46) on each side of the mower.
6. Slide the leveling brackets onto the mounting pins and
secure them with the washers and hairpin cotters
(Fig. 46).
7. Attach the front support rods to the tractor with the
clevis pins and hairpin cotters (Fig. 45).
8. Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt, page 31.

Servicing the Fuse

The electrical system is protected by fuses. It requires no
maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse: Main F1—30 amp, blade-type
Charge Circuit F2—25 amp, blade-type
Optional Headlight Kit—10 amp, blade type (Model
74350 only)
1. Raise the seat to gain access to the fuse holder (Fig. 47).
2. To replace a fuse, pull out on the fuse to remove it
(Fig. 47).
4
3
1. Main—30 amp
2. Charge circuit—25 amp
3. For optional Headlight
Kit—10 amp (Model
74350 only)
32
2
1
Figure 47
4. Battery
m–6420