Table of Contents
Advertisement
INSTALLING THE PANEL
POWERING THE PANEL
Note: This unit must be powered by a 24-hour, 120 V, 60 Hz or 230-240 VAC, 50 Hz circuit (as appropriate for your country) that cannot be turned off by
a switch, dimmer, or Residual Current Device. Failure to provide this circuit may prevent it from providing constant protection. Power supply shall be
located within same room as control unit.
Connect power supply.
WARNING!
Use included 7v⎓DC
If using the provided cable, the "striped" wire is (+)
Note: Power supply shall be located within same room as control unit
Power Supply ONLY
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE
12
OF
Press and hold the power button on
the right side of the panel for 3
seconds to power up.
197
Advertisement
Table of Contents
