Installing The Canopy; Installing The Blades - Hunter 52613 Installation Manual

Swing the fan up to align the
canopy screw holes with the
mounting holes on the ceiling plate.
Note: The slots in the canopy must
remain engaged while swinging the
canopy for alignment.
Partially install a canopy screw, found
in the
the ceiling plate hooks. When all the
holes are properly aligned, securely
tighten all three canopy screws.
Note:
Fan style may vary.
Note:
Fan style may vary.
Ceiling Bracket Top housing
Canopy
bag Screws
hardware bag, between
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Hanging Fan

Installing the Canopy

Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the
holes opposite the ceiling plate hooks.
1 of 3
Note: Should you need to remove the trim ring,
press firmly on opposite sides of the trim ring. The
tabs will flex out releasing the canopy trim ring.

Installing the Blades

Put the blade washers found in the
bag onto the blade screws found in the
hardware bag. Then install the blade screws to
secure each blade to the fan.
Repeat x5
Wiring Canopy
hardware bag, into the
Using both hands, push the canopy trim
ring up to the top of the canopy. The canopy
trim ring will snap and lock into place.
hardware
bag
bag
Blades Light
1886
2 of 3
Canopy
bag Screws
x15
Blade Screw
x15
Blade Washer
6
Glass/Bulbs