7 Unit installation
In this chapter
7.1 Preparing the installation site
7.1.1 Installation site requirements of the outdoor unit
ERGA04~08EAV3+V3A+V37 + EHSH/X(B)04+08P30+50EF
Daikin Altherma 3 R ECH₂O
4P678716-1A - 2022.07
7.1
Preparing the installation site ................................................................................................................................................
7.1.1
7.1.2
7.1.3
7.1.4
7.1.5
Installation patterns ...............................................................................................................................................
7.2
Opening and closing the units................................................................................................................................................
7.2.1
About opening the units ........................................................................................................................................
7.2.2
To open the outdoor unit ......................................................................................................................................
7.2.3
To close the outdoor unit.......................................................................................................................................
7.2.4
To open the indoor unit .........................................................................................................................................
7.2.5
7.2.6
To close the indoor unit .........................................................................................................................................
7.3
Mounting the outdoor unit ....................................................................................................................................................
7.3.1
7.3.2
7.3.3
7.3.4
To install the outdoor unit .....................................................................................................................................
7.3.5
To provide drainage ...............................................................................................................................................
7.3.6
7.4
Mounting the indoor unit.......................................................................................................................................................
7.4.1
About mounting the indoor unit............................................................................................................................
7.4.2
7.4.3
To install the indoor unit........................................................................................................................................
7.4.4
Choose an installation location with sufficient space to transport the unit in and
out of the site.
Do NOT install the unit in places often used as work place. In case of construction
works (e.g. grinding works) where a lot of dust is created, the unit MUST be
covered.
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
WARNING
DO NOT reuse refrigerant piping that has been used with any other refrigerant.
Replace the refrigerant pipes or clean thoroughly.
INFORMATION
Also read the following requirements:
▪
General installation site requirements. See the "General safety precautions"
chapter.
▪
Refrigerant piping requirements (length, height difference). See further in this
"Preparation" chapter.
7
Unit installation
|
65
65
68
69
70
72
77
77
77
78
78
79
81
81
81
81
81
84
85
87
88
88
88
88
88
Installer reference guide
65