Network Daughter Card; Removing The Network Daughter Card - Dell Precision Rack 7910 Owner's Manual

Steps
1. Align the end of the integrated storage-controller card opposite the connector with the integrated storage-controller card
holder.
2. Lower the connector side of the integrated storage-controller card into the integrated storage-controller card connector on
the system board.
Ensure that the tabs on the system board align with the screw holes on the integrated storage-controller card.
3. Align the screws on the integrated storage-controller card cable with the screw holes on the connector.
4. Tighten the screws to secure the integrated storage-controller card cable with the integrated storage-controller card
connector on the system board.
Next steps
1. Replace the expansion-card riser 1.
2. Replace the cooling shroud.
3. Follow the procedure listed in

Network daughter card

Removing the network daughter card

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. If installed, remove expansion card(s) from the expansion-card riser 2 and 3.
4. Keep the #1 Phillips screwdriver handy.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
Steps
1. Using a #1 Phillips screwdriver, loosen the captive screws that secure the network daughter card to the system board.
2. Hold the network daughter card by the edges on either side of the touch point and lift the card to remove it from the
connector on the system board.
3. Slide the network daughter card away from the back of the system until the Ethernet connectors are clear of the slot in the
back panel.
4. Lift the network daughter card out of the chassis.
60 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.