Pcie Card Holder; Removing The Pcie Card Holder - Dell Precision Rack 7910 Owner's Manual

2. If installed, remove the USB key.
3. Insert the new USB key into the USB connector.
Figure 14. Replacing the internal USB key
a. USB memory key
b. USB memory key connector
Next steps
1. Follow the procedure listed in After working inside your system.
2. While booting, press <F2> to enter the System Setup and verify that the USB key is detected by the system.

PCIe card holder

Removing the PCIe card holder

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. If installed, remove the full-length PCIe card.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
CAUTION: Do not use your system without the PCIe card holder installed. The PCIe card holder is necessary to
ensure proper system cooling.
Steps
1. Press the release tab and slide the card holder toward the back of the chassis to release the PCIe card holder from the
chassis.
2. Lift the PCIe card holder out of the chassis.
NOTE: To ensure proper system cooling, you must replace the PCIe card holder.
Safety instructions.
Before working inside your system.
Installing and removing system components 37