Installing Expansion-Card Risers; Gpu Card Installation Guidelines - Dell Precision Rack 7910 Owner's Manual

Figure 27. Identifying connectors on the expansion card riser 3 (alternate)
a. expansion-card slot 6
b. power connector (for GPU cards)
Next steps
1. If applicable, remove or install an expansion card on the riser.
2. If applicable, replace the expansion-card riser.
3. Follow the procedure listed in

Installing expansion-card risers

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. If applicable, reinstall the expansion card(s) into the expansion-card riser 1.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
Steps
1. Align the expansion-card riser with the connectors and the riser guides on the system board.
2. Lower the expansion-card riser into place until the expansion-card riser is fully seated in the connector.
Next steps
1. Install the expansion card(s) into the expansion-card risers 2 or 3.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

GPU card installation guidelines

NOTE: Internal GPU cards are supported on the Precision Rack 7910.
● The Precision Rack 7910 must be installed with one processor for 5, 6, 7 PCIe slots.
● If quantity 2 K6000 or K20 Cards are used along with 160 w processors, the system inlet temperature is restricted to 30 c to
ensure adequate system cooling.
After working inside your
Safety instructions.
Before working inside your
After working inside your
system.
system.
system.
Installing and removing system components 51