6. Remove the pump housing assembly from the
motor (F
. 4).
IG
Motor
Pump Housing Assembly
F
. 4
IG
Reassembly
1. Put the pump housing assembly onto the motor.
The motor shaft key should match the slot on the
gear on the inside cover (F
Motor Shaft Key
F
. 5
IG
3A8558C
. 5).
IG
Gear Slot
2. The pump outlet should face up and the motor
capacitor and the outlet should both be on top (F
6).
Motor Capacitor
F
. 6
IG
3. Place and tighten the four Allen screws (6) using an
5/16 in. (8 mm) hex wrench (Torque 20 ft-lbs, 27.1
N•m) (see F
. 3).
IG
4. Complete using the Installation information
beginning on page 6.
Clean and Inspect Pump Gears
Disassembly
1. Follow Pressure Relief Procedure. page 7.
2. Turn off and disconnect the power to the pump.
3. Remove the pump from the tank.
4. Remove the suction tube from the pump.
Repair
.
IG
Outlet
13