Front And Flat Bed Extension Covers; Front Cover; Flat Bed Extension Cover; Waste Tray - Singer S0700 Instruction Manual

Front and Flat Bed Extension Covers

Front Cover

Open by pushing the cover to the right as far as it will go and
then pull it toward you.
Close it again by pulling the cover upward and then sliding it
to the left until it locks.
Note: The front cover has a safety switch and the machine
will not sew if the front cover is open.

Flat Bed Extension Cover

Pull and swing the cover to the left to open. Swing it back
and push in place to close.
Note: The flat bed extension cover has a safety switch and
the machine will not sew if it is opened.

Waste Tray

A
The waste tray collects trimmings. Make sure the trim falls
into the tray while sewing. Empty the tray after sewing.
Place the tray along the edge of the flat bed extention (A).
Push the waste tray towards the front cover inserting the tabs
into the slit under the front cover (B). Push until it clicks in
place.
Pull the waste tray toward you to remove it.
B

Handwheel

By turning the handwheel you can raise and/or lower the A
needles manually. Always turn the handwheel toward you.
B
When threading, adjusting the stitch finger lever or connect-
ing/disconnecting the 2-thread overlock converter, the hand
wheel should be set to locked position.
Put the "Threading/Sewing" switch in "Threading position"
(A). To lock the handwheel, match the mark on the cover (B)
with the mark on the handwheel (C).
C
8 – ABOUT YOUR MACHINE