Using The Needle Threader - Singer S0700 Instruction Manual

Using the Needle Threader

Turn off the main power switch and unplug the machine.
Set the Threading/Sewing switch to "Threading" position
by turning it to the right.
Turn the handwheel slowly toward you until the mark on
the wheel matches the mark on the cover (A). The hand
wheel will click and is locked in threading position.
Lower the presser foot lifter (B).
Set the needle threader switch to "R" when threading the
right needle.
Set the needle threader switch to "L" when threading the left
needle.
Pull down the needle threader lever (A) as far as it will go.
Draw the thread along the guide (B) on the needle threader
switch from the left and under the hook (C).
Make sure that the thread or your finger does not touch the
upper looper or the upper cutter.
Slowly raise the threader lever (D) so that a loop of the
thread is pulled through the needle (E).
Pull the thread loop out behind the needle.
Set the Threading/Sewing switch to "Sewing" position.
Close the front cover.
24 – GETTING READY TO SEW
B
L
A
D
A
R
B
E
C