Related Manuals for Hunter 50786
Summary of Contents for Hunter 50786
- Page 1 Melbourne Installation Manual Model: 50786 Matte Black 50788 Noble Bronze 50789 Brushed Nickel Fan weight ±2 lbs: 13.9 lbs (6.3 kg) ©2020 Hunter Fan Co. PG3898 r031820...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 30° you will also need an Angled Mounting Kit. -
Page 5: Installing The Ceiling Bracket
Installing the Ceiling Bracket You have two options for installation. Pick which one works best for your location. Remove any existing bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. Hunter Pro Tip:... -
Page 6: Hanging The Fan
1886 Hanging the Fan NOTICE To prevent damage to fan, ALWAYS lift holding either the fan housing or the downrod. Place the downrod ball into the slot in the ceiling bracket. Note: Fan style may vary. Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades... -
Page 7: Wiring The Fan
If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. You are going to need these: Hunter Pro Tip: Here is how to connect the wires: 4 Wire Nuts (these are in the... -
Page 8: Installing The Canopy
1886 Installing the Canopy Insert the two canopy screws found in the hardware bag. Canopy Screw Lift the canopy into place so that NOTICE the screw holes are aligned. If screw holes do not align properly then rotate the canopy Note: 180 degrees. -
Page 9: Assembling The Light Kit
1886 Assembling the LIght Kit 1 of 3 2 of 3 Light Kit Screw Light Kit Screw Feed the wire plugs through the center hole of the upper switch Partially install two light kit housing and gasket, then wrap Insert the third screw, found in the keyhole slots around the screws screws, found in the hardware bag, into place and... -
Page 10: Preparing The Remote
1886 Preparing the Remote Battery Door ON ECE Once the power ON ECE is turned on, the remote must be remote must be ON ECE paired within 60 paired within 60 seconds seconds. Pairing To change the battery, remove the Battery (If a light kit is installed) is only required... -
Page 11: Troubleshooting
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,... - Page 12 1886 Downrod If you need a different downrod length follow these steps: Follow steps 1-5 to remove standard downrod pipe Follow steps 6-10 to reassemble with new downrod WARNING FAN FALL HAZARD To prevent SERIOUS INJURY or DEATH: • ALWAYS follow the downrod assembly instructions exactly.