Hunter Churchwell Installation Manual page 9

1
Screw two light kit screws from
the hardware bag halfway
into the motor housing. It does
not matter which two screw
holes you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
Socket
Ring Tool
Remove the socket rings from the sockets. Install the
shades onto the sockets. Install the socket rings onto
the sockets. Tighten them by turning clockwise with
the socket ring glass tool.
Repeat x3
Note:
Fan style may vary.
Ceiling Bracket Downrod
Assembling the Light
2
2 of 6
Light Kit Screw
bag
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
5
Partially install two of the light kit screws
found in the hardware bag. Align the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Installing the Bulbs and Glass
Socket
Shade
Socket
Ring
Hanging Fan Wiring
3
2 of 6
6
Light Kit Screw
bag
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy Blades
Light Kit Screw
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
Light Kit Screw
bag
Install the last light kit screw.
Tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
ON
Light Glass/Bulbs
1886
1 of 6
1 of 6
8