geneRAl SAfety RuleS recommended. ■ Inspect the backing pad before each use. Do not use if ■ For multiple hazards, read and understand the safety cracked or broken or if it has been dropped. instructions before installing, operating, repairing, maintaining, changing accessories on, or working near ■...
or hydraulic hose. it is in place and in good working order when the tool is being operated. ■ The sander or polisher is not intended for use in potentially explosive atmospheres and is not insulated vIBRAtIOn hAzARdS against contact with electric power. The information for use shall draw attention to vibration ■...
ReSIduAl RISkS Even if you are operating this product in accordance CE conformity with all the safety requirements, potential risks of injury and damage remain. The following dangers can arise in Please read and understand all instructions connection with the structure and design of this product: before operating the product, follow all 1.
● It is most important that the product be properly ■ To adjust the angle of the sanding head: lubricated by keeping the air line lubricator filled See Figure 5 and correctly adjusted. Without proper lubrication 1. Loosen the angle adjustment hex bolt. the product will not work properly and parts will 2.
pROBleM: tool will not run. Air flows freely from environment. exhaust. ■ Check the speed after each service in relevant cases. pOSSIBle cAuSe tROuBleShOOtIng One or more motor vanes are stuck due to material build up. WARnIng ReMedIeS If any of the following symptoms appears during ■...