Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ryobi R18BP
Summary of Contents for Ryobi R18BP
- Page 1 ORIGINAL INSTRUCTIONS 18 VOLT BUFFER/POLISHER R18BP...
- Page 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
- Page 3 Fig. 1...
- Page 4 Fig. 2 Fig. 3 Fig. 4 Fig. 5...
- Page 5 Fig. 6 Fig. 7 Fig. 8...
-
Page 6: General Power Tool Safety Warnings
Safety tool. Do not use a power tool while you are GENERAL POWER TOOL SAFETY WARNINGS tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious WARNING personal injury. Read all safety warnings and all instructions. - Page 7 Safety power tool repaired before use. Many accidents of the power tool “live” and could give the operator an are caused by poorly maintained power tools. electric shock. f) Keep cutting tools sharp and clean. Properly ■ Know your power tool. Read operator’s manual maintained cutting tools with sharp cutting edges carefully.
-
Page 8: Intended Use
Safety also. OPERATION TRANSPORTING LITHIUM BATTERIES WARNING Transport the battery in accordance with local and national provisions and regulations. Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second Follow all special requirements on packaging and labelling is sufficient to inflict severe injury. -
Page 9: Maintenance
Safety water solution. For removal of stubborn dirt such as road being polished. tar, grease, and bug stains, you can use a mild ammonia Begin by polishing larger flat surfaces, such as the hood, solution such as that used in glass cleaners. Before using trunk and roof. -
Page 10: Environmental Protection
Safety APPLICATION AND BUFFING/POLISHING BONNETS Both the application and buffing/polishing bonnets are reusable. For maximum life and performance, hand wash after use and allow them to air dry. If needed, the bonnets can be machine washed in cold water with a small amount of detergent, then machine dried using low heat. -
Page 11: Product Specifications
PRODUCT SPECIFICATIONS BATTERY AND CHARGER Voltage 18 V Model Compatible battery pack Compatible charger (not included) (not included) Buffing pad size 152 mm (6”) Lithium-Ion RB18L13 BCS618G Orbit diameter 10 mm (3/8”) RB18L15 BCL14181H RB18L26 BCL14183H No-load speed 4,000 min RB18L40 BCL1418IV* Nickel... - Page 12 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 21May2014v1...