Ryobi RPS1201 Original Instructions Manual
Ryobi RPS1201 Original Instructions Manual

Ryobi RPS1201 Original Instructions Manual

Cordless 12v palm sander

Advertisement

ORIGINAL INSTRUCTIONS
Cordless 12V Palm Sander
RPS1201

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi RPS1201

  • Page 1 ORIGINAL INSTRUCTIONS Cordless 12V Palm Sander RPS1201...
  • Page 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
  • Page 3: General Power Tool Safety Warnings

    Safety operating power tools may result in serious GENERAL POWER TOOL SAFETY WARNINGS personal injury. b) Use personal protective equipment. Always WARNING wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat or Read all safety warnings and all instructions. Failure hearing protection used for appropriate conditions to follow the warnings and instructions may result in will reduce personal injuries.
  • Page 4: Special Safety Rules

    Safety are less likely to bind and are easier to control. ■ Do not use sanding paper larger than needed. Extra paper extending beyond the sanding pad can also g) Use the power tool, accessories and tool bits cause serious lacerations. etc, in accordance with these instructions, taking into account the working conditions and ■...
  • Page 5: Environmental Protection

    Safety BATTERY OVERLOAD PROTECTION This tool is designed to protect the battery from overloading. When overloading is detected, the tool will automatically switch off and all LEDs on the fuel gauge will flash. To resume operation, switch the tool off and on again. If the tool fails to operate, it means battery pack is discharged and should be recharged in a compatible charger.
  • Page 6 Getting started...
  • Page 7 Operation...
  • Page 8: Maintenance

    Maintenance...
  • Page 9 Maintenance...
  • Page 10: Product Specifications

    Voltage 12 V Model Compatible battery pack Compatible charger (not (not included) included) No load speed 11,000 min RPS1201 BSPL1213 BCL12L1H No load orbital stroke rate 22,000 min RB12L13 Main sanding sheet surface 113.5 cm Flip down finger surface 10.3 cm...
  • Page 11 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 27 Clemow Drive Mt. Wellington, Auckland 1060, New Zealand...

Table of Contents