Fisher & Paykel DishDrawer DD60D2NX9 User Manual page 42

'A' fault codes
Follow the steps below to try and fix the issue.
DISPLAY POSSIBLE CAUSE
A1
Water supply fault.
A3
Drawer cannot drain. The
drainage hose may be
blocked or kinked, or the
connection to drainage
pipe may be blocked.
A6
Spray arm has loosened
or come off its
mounting.
Water pressure is too
low. You may need a
4-litre valve installed on
your water supply.
A7
Auto recovery program:
DishDrawer™ Dishwasher
has detected excess
foam in the drawer.
A09
Sanitize cycle hasn't met
temperature needed to
sanitize dishes.
42
FAULT CODES
WHAT TO DO
1 Ensure the water supply is turned on.
2 Press
again to clear the fault.
3 Press to resume the wash program.
1 Ensure the drainage hose and connection to
pipes are not blocked.
2 Press
again to clear the fault.
3 Press to resume the wash program.
1 Open the drawer and check the spray arm.
2 If the spray arm has loosened or come
off its mounting, re-fit it. Check that
it is firmly seated and turns freely.
Refer to 'Maintenance'.
3 Press
again to clear the fault.
4 Press to resume the wash program.
1 Disconnect from the power supply and
water supply, then contact Customer Care.
1 Let the auto recovery program run until it
is complete. The wash program will resume
when the auto recovery program has
completed.
2 Check that you are using the right detergent
before running another wash program.
3 If the drawer is still filled with foam at
the end of the wash program, contact
Customer Care.
1 Check if the water supply has been turned
off or the wash program interrupted.
2 Press
again to clear the fault.
3 Run the sanitize cycle again.
once to stop the beeping, then
once to stop the beeping, then
once to stop the beeping, then
once to stop the beeping, then