Fisher & Paykel DishDrawer DD60D2NX9 User Manual page 14

Using
SANITIZE
The wash modifier adjusts the wash program to meet the conditions required by
SANITIZE
Section 6, NSF 184 for sanitization to occur. While
monitored to ensure that these conditions are met.
Only programs using the
required by Section 6, NSF 184. Other wash programs may not reach the temperatures
required for sanitization to occur. See table on previous page for wash programs that have
sanitize available.
For sanitization to occur, the temperature of the water needs to reach 70°C. Ensure all
items are dishwasher safe before running the sanitize modifier.
If the wash is interrupted or the water supply is turned off during the program, the heating
conditions for sanitization may not be met. You may need to run the program again.
14
WASH MODIFIERS
wash modifier are certified to meet the conditions
SANITIZE
is running, the wash program is
SANITIZE
If sanitization has been successful
The DishDrawer™ Dishwasher will beep,
will show in the display and the
indicator will remain lit. After 30 seconds the
display will turn off.
If sanitization has not been successful
An alert will sound and an alert code will
show in the display. The
will not be lit.
1 Check if the water supply has been turned
off or the wash program interrupted.
2 Press once to stop the beeping and
then again to clear the alert code.
3 Run the
SANITIZE
For more information, refer to 'Fault codes'.
SANITIZE
indicator
SANITIZE
cycle again.
0