Table of Contents
Advertisement
686
8-2. Steps to take in an emergency
To inject the sealant and inflate
13
the tire, turn the compressor
switch on.
Inflate the tire until the specified air pressure is reached.
14
The sealant will be injected
1
and the pressure will spike to
between
3.0 kgf/cm
58 psi (400 kPa, 4.0 kgf/cm
or
bar),
decrease.
The air pressure gauge will
2
display the actual tire infla-
tion pressure about 1 to 5
minutes after the switch is
turned on.
• Turn the compressor switch
off and then check the tire
inflation
careful not to over inflate,
check and repeat the inflation
procedure until the specified
tire
inflation
reached.
• The tire can be inflated for about 5 to 20 minutes (depending on
the outside temperature). If the tire inflation pressure is still lower
than the specified point after inflation for 25 minutes, the tire is
too damaged to be repaired. Turn the compressor switch off and
contact your Toyota dealer.
• If the tire inflation pressure exceeds the specified air pressure, let
out some air to adjust the tire inflation pressure. (P. 689, 723)
PRIUS PRIME_OM_OM47D13U_(U)
44 psi
(300 kPa,
2
or
bar)
and
2
then
gradually
pressure.
Being
pressure
is
Advertisement
Table of Contents
