Table of Contents
Advertisement
Features
280
The garage door opener is compatible with
devices which operate in the frequency range
of 280 to 433 MHz.
Replace the batteries in garage door remote
R
control A. This increases the likelihood that
garage door remote control A will transmit a
strong and precise signal to the integrated
garage door opener.
When programming, hold remote control A
R
at varying distances and angles and from but-
tons ; to ? which you are programming. Try
various angles at a distance between 2and
8 inches (5to 20 cm) or at the same angle but
at varying distances.
If another remote control A is available for
R
the same garage door drive, repeat the same
programming steps with this remote control
A. Before performing these steps, make sure
that new batteries have been installed in
garage door drive remote control A.
Note that some remote controls only transmit
R
for a limited amount of time (the indicator
lamp on the remote control goes out). Press
button B on remote control A again before
transmission ends.
Align the antenna cable of the garage door
R
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of the
garage door system remote control. Please also
read the operating instructions for the garage
door system.
Turn the SmartKey to position 2 in the igni-
X
tion lock (
page 123).
Y
Press button ;, = or ? which you pro-
X
grammed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code: indi-
cator lamp : flashes green.
The transmitter will transmit a signal as long
as the button is pressed. The transmission is
halted after a maximum of ten seconds and
indicator lamp : lights up yellow.
Press button ;, = or ? again if necessary.
X
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling the
vehicle.
Turn the SmartKey to position 2 in the igni-
X
tion lock (
page 123).
Y
Press and hold buttons ; and ?.
X
The indicator lamp initially lights up yellow
and then green.
Release buttons ; and ?.
X
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
Floormats
G
WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats and do not place floormats on
top of one another.
Slide the relevant seat back.
X
To install: place the floormat in the footwell.
X
Press studs : onto retainers ;.
X
To remove: pull the floormat off retainers ;.
X
Remove the floormat.
X
Advertisement
Table of Contents
