Table of Contents
Advertisement
Another function of the Vehicle Health Check is
the transfer of service data to the Customer
Assistance Center. If a service is due, the display
shows a message to this effect together with
information about any special offers at your
workshop.
This information can also be called up under
"Owners Online" at http://www.mbusa.com.
Information on the data stored in the vehicle
(
page 32).
Y
Information on Roadside Assistance
(
page 29).
Y
Downloading routes
Downloading routes allows you to transfer and
save predefined routes in the navigation sys-
tem.
A route can be prepared and sent by either a
customer service representative or under "Own-
ers Online" at http://www.mbusa.com.
Each route can include up to four way points.
Once a route has been received by the naviga-
tion system, you will see the
start route guidance? Destination
Received destination has been saved
in "Previous destinations".
the multimedia system display.
The route is saved.
To start route guidance: select Yes.
X
An overview of the route is shown in the dis-
play.
If you select No, the saved route can be called
up later in the navigation menu.
Select Start.
X
Route guidance starts.
Downloaded and saved routes can be called up
again.
Speed alert
You can define the upper speed limit, which
must not be exceeded by the vehicle.
If this selected speed is exceeded by the vehicle,
a message will be sent to the Customer Assis-
tance Center. The Customer Assistance Center
then forwards this information to you.
You can select the way in which you receive this
information beforehand. Possible options
include text message, e-mail or an automated
call.
The data you receive contains the following
information:
R
R
R
Geo fencing
Geo fencing allows you to select areas which the
vehicle should not enter or leave. You will be
informed if the vehicle crosses the boundaries
of the selected areas. You can select the way in
which you receive this information beforehand.
Possible options include text message, e-mail or
an automated call.
The area can be determined as either a circle or
a polygon with a maximum of ten corners. You
can specify up to ten areas simultaneously. Dif-
ferent settings are possible for each area.
These settings can be called up under "Owners
Online" at http://www.mbusa.com.
Do you want to
Alternatively, you can trigger an Info call and
notify the customer service representative that
you wish to activate geo-fencing.
message on
Currently inactive areas can be activated by text
message.
Triggering the vehicle alarm
With this function, you can trigger the vehicle's
panic alarm via text message. An alarm sounds
and the exterior lighting flashes. Depending on
the setting, the panic alarm lasts five or ten sec-
onds. Afterwards, the alarm switches off.
General notes
The HomeLink
in the rear-view mirror allows you to operate up
to three different door and gate systems.
Use the integrated garage door opener only on
garage doors that:
R
R
Once programed, the integrated garage door
opener in the rear-view mirror will assume the
function of the garage door system's remote
the location where the speed limit was excee-
ded
the time at which the speed limit was excee-
ded
the selected speed limit which was exceeded
Garage door opener
®
garage door opener integrated
have safety stop and reverse features and
meet current U.S. federal safety standards
Features
277
Z
Advertisement
Table of Contents
