Table of Contents
Advertisement
Conettix Plug-in Communicator
1. Modify
Diagnostic
Settings
2. Re-print
Saved Console
Message
3. Enable Live
Console
Messages
6.7
Network polling
Plan carefully when programming the control panel poll time, ACK wait times, retries, and
D6x00 Receiver poll and supervision time. If you enter the incorrect control panel settings,
trouble conditions can happen when the network carrier performs maintenance. Trouble
conditions can increase data volumes that affect your monthly cost. Your settings for these
parameters determine how the system works, but depend on the security leve.
For more information regarding proper data plans and installation parameters related to
network polling, refer to Bosch Cellular Service User Guide (P/N: F01U273558).
6.8
Control panel programming using cellular
For more information regarding proper planning and installation parameters related to VPN
setup for control panel programming, refer to Bosch Cellular Service User Guide (P/N:
F01U273558).
6.9
RPS Diagnostics
You can view B450 status information for SDI2 control panels in the Diagnostics window in
RPS. The information shown and the path for the content depends on the control panel
firmware version:
–
–
–
Bosch Security Systems, Inc.
Diagnostic logging is intended for use only under Bosch direction.
Diagnostic settings determine which types of messages to show.
Prints any diagnostic messages that have already occurred and are stored in
the module's buffer.
Provides real time output of diagnostic messages. This allows the computer
running TeraTerm to log module information for longer periods of time.
Firmware v2.03+. Diagnostics > SDI2 > B450 Bus Device Cellular
Firmware v2.00 - v2.02. Diagnostics > SDI2 > Ethernet Communicator
Firmware v1.xx. Diagnostics > SDI2 > B420 Ethernet Communicator
Installation Manual
Maintenance and troubleshooting | en
2018.10 | 10 | F.01U.300.740
45
Advertisement
Table of Contents
