Installation Types (Choose A, B Or C); Outside Top Exhaust (Vertical Duct) - Blomberg BOTR30100B Installation Manual

Installation
5
5.2 Installation types (choose
A, B or C)
this microwave oven is designed for adaptation to
the following three types of ventilation:
• Outside Top Exhaust (Vertical Duct Type A)
• Outside Back Exhaust (Horizontal Duct Type B)
• Recirculating (Non-Vented Ductless Type C)
Over The Range Convection Microwave Oven / Installation Manual
5.2.1 Outside top exhaust
(vertical duct type A)
Adaptor in Place for
Outside Top Exhaust installation overview
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Adapting Microwave Blower for
A4. Check Damper Operation
A5. Mount Microwave Oven
A6. Adjust Exhaust Adaptor
A7. Connect Ductwork
Adaptor Must Be
Moved to the Back for
Outside Back Exhaust
This microwave is shipped assem-
C
bled for Recirculating. Select the
type of ventilation required for your
installation and proceed to that sec-
tion.
Make sure the screws for the blower
A
motor and blower plate are securely
tightened when they are reinstalled.
This will help to prevent excessive
vibration.
A
Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
3/8" TO EDGE
along the dotted line.
Trim the rear wall template
12"
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
serves to position the bottom 4"
mounting plate and to locate This Rear Wall Template the horizontal exhaust
1. Use a level to check outlet. that the template is positioned
accurately. one stud on the left or
2. Locate and mark at least
right side of the centerline. least one wood
It is important to use at a stud to support the weight
of the microwave. Mark screw mounted firmly in two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked for wood screws. For holes locations. Where there is
a stud, drill a 3/16" hole a stud, drill 5/8" holes for
that do not line up with
toggle bolts. DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME. 4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTANT: STUD ON EITHER SIDE OF
LOCATE AT LEAST ONE
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
IN THE MOUNTING PLATE
SPACED TOGGLE BOLTS
AREA. Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT: STUD ON EITHER SIDE OF
LOCATE AT LEAST ONE
THE CENTERLINE. FOR 2 ADDITIONAL, EVENLY
along the dotted line. MARK THE LOCATION IN THE MOUNTING PLATE
Trim the rear wall template SPACED TOGGLE BOLTS
AREA.
17 / 63 EN