Enclosure Preparation; Electrical Preparation; Preparation For Installing Mounting Brackets; Adjusting Height - Blomberg DWT 25502 B Installation Manual

6. ENCLOSURE PREPARATION

6.1 ELECTRICAL PREPARATION

WARNING
The dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected
to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker
rated for 15 amperes.

6.2 PREPARATION FOR INSTALLING MOUNTING BRACKETS

A
Place the two mounting brackets into
the top corners of the dishwasher.
Fix the mounting brackets (A) to the
top corners of the dishwasher, with the
screws supplied.
Bend sides of mounting brackets (B) in
order to fix from sides (if necessary).
B
6
WARNING
Dishwasher must be secured to
adjacent cabinetry using the mounting
brackets provided. Failure to do this
may cause damage to property or
bodily injury.

6.3 ADJUSTING HEIGHT

If the height of the enclosure is 337/8" to
357/8" (861 mm - 911mm) adjust supports
as shown in the figure.
USA
B
A
Supplied (4)
15 /
1 ”
16
(50mm)