Preparing The Water Connection (A) - Blomberg DWT 25502 B Installation Manual

6.5 PREPARING THE WATER
CONNECTION (A)
Install an easily accessible shut-off valve
(not supplied) in the water supply line.
All solder connections must be made
before the water line is connected to the
dishwasher's water inlet valve. Water can
also be supplied to the dishwasher by using
a flexible braided hose line.
Check with your plumbing supply sources
for the proper hose and 90° elbow and
necessary fittings for the water supply line.
This material is not supplied, and must be
purchased separately.
WARNING
Installation should be performed by a
qualified installer. Work by unqualified
persons could be dangerous and may
void the warranty.
If the dishwasher is installed in a
location that experiences freezing
temperatures (e.g. in a vacation home,
cabin etc.), you must drain all the water
from the dishwasher's interior. Water
system ruptures that occur as a result of
freezing are not covered by warranty.
B
6.5.1 INSTALLING THE 90° ELBOW
FITTING (B)
CAUTION
Do not over tighten the 90° elbow. Doing
so may damage the water inlet valve and
cause a water leak.
If the water supply line is to be copper
tubing, make certain that the elbow has a
compression fitting. Apply Teflon tape or
other pipe sealant when required. Orient
the water supply connection downwards as
shown in the figure so the water line can be
easily pulled underneath or on the side of
the dishwasher.
A
8
USA