Table of Contents
Advertisement
www.seagate.com
1.2.11
HDD and SSD Regulatory Compliance and Safety
For the latest regulatory and compliance information see:
the Compliance, Safety and Disposal Guide link.
1.2.11.1
Regulatory Models
The following regulatory model number represent all features and configurations within the series:
Regulatory Model Numbers: STL006
1.2.12
Corrosive environment
Seagate electronic drive components pass accelerated corrosion testing equivalent to 10 years exposure to light
industrial environments containing sulfurous gases, chlorine and nitric oxide, classes G and H per ASTM B845.
However, this accelerated testing cannot duplicate every potential application environment.
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive
chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper,
nickel and gold films used in hard disk drives are especially sensitive to the presence of sulfide, chloride, and nitrate
contaminants. Sulfur is found to be the most damaging. Materials used in cabinet fabrication, such as vulcanized
rubber, that can outgas corrosive compounds should be minimized or eliminated. The useful life of any electronic
equipment may be extended by replacing materials near circuitry with sulfide-free alternatives.
Seagate recommends that data centers be kept clean by monitoring and controlling the dust and gaseous
contamination. Gaseous contamination should be within ANSI/ISA S71.04-2013 G2 classification levels (as measured
on copper and silver coupons), and dust contamination to ISO 14644-1 Class 8 standards, and MTBF rated conditions
as defined in the Annualized Failure Rate (AFR) and Mean Time Between Failure (MTBF) section.
1.2.13
Reference documents
Supported Standards
ANSI Documents
Specification for Acoustic Test Requirement and Procedures
In case of conflict between this document and any referenced document, this document takes precedence.
Seagate IronWolf Pro Serial ATA Product Manual, Rev. D
Serial ATA Revision 3.3 specification
INCITS 522-2014ATA/ATAPI Command Set - 3 (ACS-3)
Seagate part number: 30553-001
www.seagate.com/support/
Drive specifications
scroll down the page and click
18
Advertisement
Table of Contents
