Table of Contents
Advertisement
www.seagate.com
#
Drive specification
Temperature gradient (°C per hour max)
*
Relative humidity
Relative humidity gradient
Altitude, operating
Altitude, nonoperating (below mean sea level, max) –304.8 m to 12,192 m
Operational Shock (max at 2 ms - typical)
Non-Operational Shock (max at 2 ms - typical)
Linear Random Operating Vibration
Random Rotary Operating Vibration
Linear Random Non-Operating Vibration
Drive acoustics, sound power (bels)
***
Idle
Performance seek
Nonrecoverable read errors
Annualized Failure Rate (AFR)
Maximum Rated Workload
Warranty
Load-unload cycles (command controlled)
Supports Hotplug operation per
Serial ATA Revision 3.3 specification
#
All specifications above are based on native configurations.
*
See
Section 1.2.10, "Reliability"
**
One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity.
Accessible capacity may vary depending on operating environment and formatting.
***
During periods of drive idle, some offline activity may occur according to the S.M.A.R.T.
specification, which may increase acoustic and power to operational levels.
†
Seagate does not recommend operating at sustained drive temperatures above 60°C.
Operating at higher temperatures may affect drive health.
Seagate IronWolf Pro Serial ATA Product Manual, Rev. D
20°C (operating)
20°C (nonoperating)
5% to 95% (operating)
5% to 95% (nonoperating)
20% per hour max
–304.8 m to 3,048 m
(–1000 ft to 10,000+ ft)
(–1000 ft to 40,000+ ft)
Read 70 Gs / Write 40 Gs
250 Gs
5–500 Hz:
20–1500Hz: 12.5 rads/s²
2–500 Hz: 2.27 Grms ref
1.8 (typical)
2.0
During periods of drive idle, some offline activity may occur according to the
SMART specification, which may increase acoustic and power to operational levels.
2.6 (typical)
2.8
1 sector per 10
*
0.73% based on 8760 POH
*
Maximum rate of <300TB/year
Workloads exceeding the annualized rate may degrade the drive MTBF and impact prod-
uct reliability. The Annualized Workload Rate is in units of TB per year, or TB per 8760
power on hours. Workload Rate = TB transferred * (8760 / recorded power on hours).
To determine the warranty for a specific drive, use a web browser to access the following
web page: www.seagate.com/support/warranty-and-replacements/.
From this page, click on the "Is my Drive under Warranty" link. The following are required
to be provided: the drive serial number, model number (or part number) and country of
purchase.The system will display the warranty information for the drive.
600,000
Yes
for rated MTBF device operating condition requirements.
0.70 Grms
(max)
(max)
15
bits read
ST10000NE0008
Drive specifications
8
Advertisement
Table of Contents
