EAW MKC Series Instructions Manual page 6

MKC Series & MKD526
Figure 4 - Locking washer is first on bolt, then flat washer, rubber washer to be inside of bracket flanges
• The outermost mounting point "A" is designed as an open slot to allow for easy
locating of the loudspeaker and loosely pre-installed hardware when using the
slotted mounting point, the bracket must be installed oriented with the slot
angled upward, opposing the ground.
• Use of the angle lock point is optional. The angle lock point is used for locking
the loudspeaker at a specific set angle.
b. Installing a loudspeaker onto a mounted bracket.
WARNING: Take care when handling and wear PPE gloves to protect from crushing and
impacts with digits, limbs, and/or product.
Note, for weather protected applications (using WP Series Loudspeakers), apply user-
supplied, waterproof, non-hardening, non-locking thread sealant to the threads of
two button head screws (B) & the single socket head screw (F) per the thread sealant's
instructions. Failure to do so could result in water ingress and damage to the loudspeaker.
• Onto each of two button head screws (B), place a split-lock washer (C) and a flat
washer (D).
• Onto each of the socket head screw (F), place a split-lock washer (H) and a flat
washer (G).
Bracket Instructions
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
6