Table of Contents
Advertisement
60
_____________________________________________________________________________________
[1] Part of active terminator circuits. Permanently mounted LSI terminators enabled in the drive (ST15230W
only) when it is first or last in the daisy-chain. See jumper header Figure 10.1-1 for terminator enabling
jumper TE.
[2] ANSI SCSI compatible circuits
[3] Total interface cable length should not exceed that specified in Section 11.6.2.2.1.
[4] Source of drive terminator power should be an active circuit which has an input source voltage selected
by jumper plug TP. See Figure 10.1-1. This applies to model ST15230W only. Refer to section 11.6.4.3 on
terminator requirement.
[5] Interface signals levels and logical sense at the drive I/O connector are defined as follows:
Logic Level
Negated (0)
Asserted (1)
The difference in the voltages between input and output signals is due to the losses in the cable.
Figure 11.6.4-1. Single ended transmitters and receivers
Product Manual - Hawk 4 Family (Wide) SCSI-2 (Volume 1), Rev. E
Line Driver
TP
Transmitter
[4]
(or transceiver)
110
[1]
Ohm
[2]
Driver Output
>2.5 V: <5.25 V
<0.4 V: >0.0 V
Line Receiver
TP
Receiver
[4]
Flat
110
Cable
[1]
Ohm
Pair
[5]
[3]
Receiver Input
>2.0 V: <5.25 V
<0.8 V: >0.0 V
[2]
Advertisement
Table of Contents
