Holmes HQH307 - Tower Quartz Heater Manual

TECHNICAL SPECIFICATIONS

• Wattage: 1500W (+5%-15%)
• Working voltage: 120V AC/60Hz

AUTO SAFETY SHUT-OFF WITH INSTANT TIP-OVER PROTECTION

This heater is equipped with a patented, technologicallyadvanced safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit.

To Reset the Heater:

1. Turn the Heat Control to the OFF (O) position.
2. Wait 15 minutes for the unit to cool down.
3. Push the reset button on the backside of the unit andoperate normally.

Tip-Over Shut Off:
When the unit is accidentally knocked over, it will instantly shut off. To reset, simply place the heater in an upright position.

MAXFLOW FAN SYSTEM

The patented MaxFlow^TM Fan system incorporates a top mounted fan and internal shroud to provide maximum heat dispersion. The Maxflow^TM Fan system is activated by using the Mode Control Knob. It delivers a combination of instant, penetrating warmth in the immediate area, as well as forcing the heat out for entire room coverage.

PRE-OPERATING INSTRUCTIONS

1. Carefully remove your heater from the box. (Please save the carton for off-season storage.)
2. Make sure the unit is in the OFF position before plugging the heater into the outlet.
3. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 watts, this unit draws 12.5 amps.

NOTE: This unit is for FLOOR USE ONLY.

OPERATING INSTRUCTIONS

1. Thermostat
2. Power Light
3. Mode Control
4. Caution Light
5. Reset Button (not visible)

1. For heater operation, please set the Thermostat all the way to HI.
2. Turn the Mode Control to desired heat setting (LO (I) for 750W or HI (II) for 1500W).
3. The Power Light will remain lit during operation.
4. Caution light illuminates in an overheat situation.

SETTING THE THERMOSTAT

1. You need to set thermostat on HI to start heater (See Figure 1 and 2). Allow heater to operate and warm up the room.
2. When the desired temperature/comfort level is reached, lower the thermostat setting until the fan/heater stops operating.
3. The control will now automatically maintain the preset temperature level by turning the heater ON and OFF.

NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting.

CLEANING/MAINTENANCE

During Season Care:
Always unplug the heater, before moving or cleaning.

1. Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor and heating elements.
2. NEVER use abrasive or flammable solvents to clean the unit.
3. After cleaning, be sure to completely dry the unitwith a cloth or towel.

After Season Care:

1. Store heater in a cool, dry location.
2. The manufacturer recommends that you store the unit in its original carton.

TROUBLESHOOTING

If your heater fails to operate:

• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions.
• The temperature may be set too low. Turn the thermostat knob clockwise until the heater restarts.
• Make sure selector is in LO (I) or HI (II) setting.

Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Holmes HQH307 - Tower Quartz Heater Manual