3.2.4
Water Lines
Water lines from the seacock to the engine-driven
seawater pump are usually constructed of flexible hose.
Connect a flexible section of hose to the seawater pump
to allow the generator set to vibrate during operation.
Support a nonflexible water line within 102 mm (4 in.) of
its connection to the flexible section.
Keep the seawater hose as straight and short as
possible. If the hose is too long, usually over 4.6 m
(15 ft.), water suction problems may occur.
Section 7 for the inlet water line hose size and the
seawater connection to the seawater pump inlet. Avoid
running the inlet pipe above the generator.
Figure 3-5 for the seawater hose connection to the
seawater pump inlet.
TP-6773 5/12a
All manuals and user guides at all-guides.com
See
See
Figure 3-5 Seawater Inlet Connection (Located at
1. Seawater pump inlet
the Inlet to the Seawater Pump), Typical
Section 3 Cooling System
1
GM75706-A
15