Table of Contents
Advertisement
5. DIRECTIONS FOR INSTALLATION AND USE
è
§ §
Location Of Washer
Check location where washer will be installed. Make sure you have everything necessary for correct installation.
Proper installation is your responsibility.
• Do not place or store your washer below 0˚C(32˚F) to avoid any damage from freezing.
• Install the washer on the horizontal sold foor.
C
A
UP
DOWN
è
§ §
Drain System
Never forget to install drain hose before operating your washer.
The packing box is opened, there are a drain hose.
• Conect the drain hose to the drain outlet at the back side of the washer.
Non-Pump Model
NOTES
The opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
1 In case that it goes over a door sill.
Don't let the height of the drain
hose exceed 20cm from the bottom
of washer.
Laundry tub drain system
• Top of tub must be at
least 86cm (34inches)
high and no higher than
130cm from bottom of
washer (A)
8
DIRECTIONS
If the washer is installed on an unsuitable floor, it could make consider-
able noise, vibrate and cause a malfunction.
If washer is not level, adjust the front leg(A) up or down for horizontal set-
ting.
• Earthed electrical outlet(B) is required with 20cm of bottom back of
B
washer cabinet.
• Hot and cold water faucets (C) must be within 1M of the upper back of
the washer cabinet and provide water pressure 0.3kgf/cm
8kgf/cm
2
(2.94N/cm
Drain hose
Non-Pump Model
2 In case of extending the drain hose.
Don't let the total length exceed 3m.
20Cm
A
2
-78.4N/cm
2
).
Drain hose
3m
Pump Model
Standpipe drain system
• Needs a 3cm minimum diameter standpipe with minimum
carry away capacity of 30liters per minute.
• Top of tub must be at
least 86cm(34inches)
high and no higher than
130cm from bottom of
washer (B)
2
-
Pump Model
Drain Outlet
3 Be careful that the end of the drain
hose is not immersed in water.
B
Advertisement
Table of Contents
