Table of Contents
Advertisement
5. DIRECTIONS FOR INSTALLATION AND USE
HOW TO INSTALL THE WASHING MACHINE
SELECTION OF THE INSTALLING PLACE
Install the washer on a horizontal solid floor.
If the washer is installed on an unsuitable floor, it
could make considerable noise and vibration.
INSTALLATION OF THE UNDER BASE COVER
1
2
\
\
Separate under
There is a
base cover from
inserting place
the unit.
under of the back
side on the
washer.
HOW TO INSTALL ON AN INCLINED PLACE
2
1
\
Check the
Height Setting
Horizontal Status
•
•
After controlling the height by
Check the position of tub above the
turning the adjustable leg, let the
center of the washer.
washer put down to the ground.
Never install in these places
•
The place where it would be exposed to
direct sunlight.
•
The place nearby a heater or heat appliance.
•
The place where it would be supposed to be
frozen in winter.
•
The kitchen with coal gas and a damp place
like a bathroom.
•
The proper installation of the washing
machine can increase the wash
effectiveness and the life of it.
After installing the washing machine,
close the under-base cover.
3
4
let the base cover
Insert the base
that can be shown
cover into the slot
the "UP" sign.
of under base until
come to the end
of the slot.
If the washer is installed on an unsuitable floor, it could make
considerable noise and vibration, and could cause a
malfunction.
NOTES :
The openings must not be
obstructed by carpeting when
the washing machine is installed
on a carpeted floor.
12
HOW TO CONNECT THE INLET HOSE
IN INSTALLING THE INLET HOSE
Be careful not to mistake in supplying hot
and cold water.
In using only one water tap, connect the
inlet hose to the cold water inlet.
3
4
Connect the water
\
Remove the
tap adapter to the
tape, and screw
water tap, and
connector B into
tighten the four
connector A
screws evenly
tightly.
while pushing up
the adapter so
that the rubber
packing can stick
to the water tap
tightly.
Connector A
Connector B
Water Tap Adapter
•
FOR SCREW-SHAPED TAP
1
\
Connect the inlet hose to the water tap by
screwing the connector D tightly.
Connector D
Rubber
Packing
Inlet Hose
Connector C
NOTE
In a high water pressure, when start with a set-up of WARM-temperature WASH, it is desirable not to turn
the faucet on. High pressure may cause on overflow rinse.
•
For Ordinary Top
1
2
\
\
Pull down the collar
Loosen the four
of the inlet hose to
screws at the water
separate it from the
tap adapter, but
water tap adapter.
don't loosen the
screw until they are
separated from the
water tap adapter.
Water Tap
Tape
Adapter
Connector A
Rubber
packing
Collar
Water
Tap
Adapter
Connector B
Connector C
5
6
\
Connect the inlet
\
Connect the inlet
hose to the
hose adapter of
water tap
the hose to the
adapter by
water inlet of the
pulling down the
washer by
collar of the hose
turning is
end.
clockwise to be
fixed tightly.
Collar
• Please check the rubber
packing inside the inlet
hose adapter of the
hose.
2
\
Connect the connector C of the inlet hose to
the water inlet of the washer by turning it
clockwise to fix it tightly.
• Please check the rubber
packing inside
the connector C
of the inlet hose
13
Advertisement
Table of Contents
