Table of Contents
Advertisement
LOG PLACEMENT FOR BRT4342 AND BRT4542 MODELS
1. Place large back log (log 1) onto grate making sure notches rest
over grate (see Figure 26).
2. Insert lower end of log 2A between first two grate fingers and
position upper end into notch on front of log 1. See Figure 26.
Place log 2B on front right side of grate as shown in Figure 26.
3. Place log 3 into notch on top left of log 1, resting lower end on
left two grate fingers (see Figure 27).
4. Place upper end of log 4 into notch on log 1 as shown in Figure
27. Rest lower end of log 4 on middle grate finger as shown in
Figure 28.
5. Place upper end of log 5 into notch on top inner right of log 1
(see Figure 28). Rest lower end of log 5 on middle grate finger
as shown in Figure 29.
6. Place log 6 into notch on top right of log 1 (see Figure 28). Rest
lower end of log 6 on top of log 2B (see Figure 29).
As an option to enhance the look of the hearth, you may place the
volcanic stone provided around front and sides of burner pan.
NOTE: It is important to ensure proper log placement per the manual
when installing these units. Verify pilot flame is not obstructed. See
Inspecting Pilot and Burner Flame Patterns on Page 19.
NOTICE: Do not put volcanic stone inside the burner
pan or around the air mixer fitting. Placing volcanic
stone inside the burner pan or blocking the openings
of the propane/LP air mixer could cause performance
problems.
1
J7242
2A
J4245
2B
J4262
3
J4244
4
J4261
5
J4243
6
J4242
Notch
Log 2A
Figure 26 - Installing Logs 1, 2A and 2B
900806-00F
INSTALLATION Continued
Log, Rear 27"
Log, Top 11"
Log, Fire Pit Rnd "Y" 15-3/4"
Log, Y Top Split 13-1/2"
Log, Firepit Split 15-3/4"
Log, Top Split 16"
Log, Top Round 11-3/4"
Log 1
Log 2B
SuperiorFireplaces.us.com
Log 3
Notches
2
A
Figure 27 - Installing Logs 3 and 4
Log 5
2
A
3
4
Figure 28 - Installing Logs 5 and 6
1
4
3
2
A
Figure 29 - Logs Installed for 42" Models
Log 4
1
2
B
Log 6
1
2
B
Notch
5
6
2
B
15
Hide quick links:
Advertisement
Table of Contents
