Nvidia DGX A100 Service Manual page 102

NVIDIA DGX A100 Service Manual
▶
Follow any designations on the slide rail to determine front/back and left-side/right-side posi-
tioning against the rack.
1. Align the bottom lip of the left or right rail to the bottom of the first rack unit for the server.
2. Attach the front of the rail to the rack.
Push the metal tab on the rail and then insert the two spring-loaded prongs into the holes on
the front rack post.
On square-holed racks, make sure the prongs are completely inserted into the hole by confirming
that the spring is fully extended.
The metal clip helps secure the rail in place while installing the rail to the rear of the rack.
3. Extend the rail to the rear post of the rack and secure the rail to the post.
Make sure that rail is level and the attachment on the rear post is at the same rack unit as the
front.
1. Insert the spring-loaded prongs into the holes on the rear rack post.
2. On square-holed racks, make sure the prongs are completely inserted into the hole by con-
firming that the spring is fully extended.
4. Repeat these steps for the other rail.
5. Secure the rails to the rack using the provided screws.
Install the four screws in the bottom holes of the rack kit.
96 Chapter 21. Installing the Rack Mount Kit