Cisco Nexus 9504 Hardware Installation Manual page 58

Installing or Replacing a Supervisor Module
1 Slide the middle handle toward the end of the ejector
lever.
2 Rotate the ejector lever away from the module.
3 Slide the back end of the module into the open
supervisor slot.
d) Rotate the lever all the way to the front of the chassis until it locks in place with a click.
Make sure that the lever engages behind the front of the slot so that the module fully seats onto the connectors on the
midplane.
e) Screw in the two captive screws to secure the module to the chassis. Tighten the screws to 8 in-lb (0.9 N·m) of torque.
f) Attach the following cables to the module:
Cisco Nexus 9504 ACI-Mode Switch Hardware Installation Guide
48
Replacing or Installing Modules, Fan Trays, and Power Supplies
4 Rotate the ejector lever to the front of the chassis.
5 Secure the chassis to the chassis by screwing in 2
captive screws and tighten them to 8 in-lb (0.9 N·m)
of torque.