Overview - Cisco Nexus 9504 Hardware Installation Manual

Overview

•
Overview
This switch chassis includes the following modules:
• Supervisor modules (one or two)—one of the following types in slots SUP 1 and SUP 2 (numbered from
• System controllers (two) (N9K-SC-A) in slots SC 1 and SC 2 (Modules 29 and 30 in reports) (numbered
• Line cards (up to four) in slots LC 1 to LC 4 (Modules 1 through 4 in reports) (numbered from top to
Note
• Fabric modules in slots FM 1 to FM 6 (Modules 21 through 26 in reports) (numbered from left to right
Overview, on page 1
left to right on the chassis)
from left to right on the chassis)
bottom on the chassis) supported by the same type of fabric module
For compatibility information, please refer to the
Do not mix ACI-mode line cards with NX-OS mode line cards in the same
switch.
on the chassis)
See the following table for the required fabric module types and quantities required for maximum
bandwidth.
Table 1: Supported Fabric Modules and Line Cards
Fabric Module
N9K-C9504-FM
C H A P T E R
Line Card and Fabric Module Compatibility
Fabric Modules Supported Line Cards
Required for
Maximum
Bandwidth
6 N9K-X9736PQ
Cisco Nexus 9504 ACI-Mode Switch Hardware Installation Guide
1
data sheets.
1