IBM eServer 260 Series Installation Manual page 40

v Information LED: When this LED is lit, it indicates that an error or warning
v Release latch: Slide this latch to the left to access the light path diagnostics
v System-error LED: When this LED is lit, it indicates that a system error has
v Locator LED: When this LED is lit, it has been lit remotely by the system
v Hard disk drive activity LED: When this LED is flashing, it indicates that a SAS
v Power-on LED: When this LED is lit and not flashing, it indicates that the server
Hard disk drive activity LED: On some server models, each hot-swap hard disk
drive has an activity LED. When this LED is flashing, it indicates that the drive is in
use.
Hard disk drive status LED: If a ServeRAID-8i adapter is installed, when this LED
is lit, it indicates that the associated hard disk drive has failed. If the LED flashes
slowly (one flash per second), the drive is being rebuilt. If the LED flashes rapidly
(three flashes per second), the controller is identifying the drive.
Diskette drive activity LED: When this LED is lit, it indicates that the diskette drive
is in use.
Diskette-eject button: Press this button to release a diskette from the diskette
drive.
CD drive activity LED: When this LED is lit, it indicates that the CD drive is in use.
CD-eject button: Press this button to release a CD or DVD from the DVD drive.
28
IBM xSeries 260 Type 8865: Installation Guide
message has been written to the system event log.
panel.
occurred. An LED on the light path diagnostics panel is also lit to help isolate the
error.
administrator to aid in visually locating the server.
hard disk drive is in use.
is turned on. When this LED is flashing, it indicates that the server is turned off
and still connected to an ac power source. When this LED is off, it indicates that
ac power is not present, or the power supply or the LED itself has failed.
Note: If this LED is off, it does not mean that there is no electrical power in the
server. The LED might be burned out. To remove all electrical power from the
server, you must disconnect the power cords from the electrical outlets.