Components - MULTIQUIP Mikasa Series Operation Manual

14
13
12
11
10
9
FRONT
Figure 1. MTX70HDR Rammer
Figure 1 shows the location of the controls and components
for the MTX70HDR Tamping Rammer. The functions of each
control is described below:
1. Fuel Tank Cap — Remove this cap to add unleaded
gasoline to the fuel tank.
2. Guide Handle — Used by the operator while standing
behind the machine to control direction and speed.
3. Combination (Throttle) Lever — Used to adjust
engine speed (rpm).
4. Fuel Tank — Holds the fuel for the unit (up to 3.2
quarts/0.8 gallons).
5. Engine — This unit uses a Honda gasoline engine.
6. Lower Lifting Handle — Used with rollers (item 6) to
facilitate the loading onto tailgate of a truck or transport
vehicle.
7. Oil Gauge (Sight Glass) — Indicates the level of oil in
the oil bath reservoir.
PAGE 12 — MTX70HDR RAMMER • OPERATION MANUAL — REV. #4 (12/01/22)
1
2
3
4
5
6
7
8
REAR
8. Drain Valve — Open this valve to remove oil from the
bellows.
9. Foot — Laminated wood with tempered steel plate for
superior shock absorption.
10. Bellows — Reservoir for oil bath.
11. Roller — Facilitates loading onto tailgate of a truck or
transport vehicle
12. Air Cleaner Cover — Protects the air cleaner which
prevents dirt and other debris from entering the engine.
13. Muffler — Reduces the noise of the engine when
running.
14. Center Lifting Point — Connection point for a lifting
hook or strap when lifting with a forklift, crane or other
machinery.

COMPONENTS