Nortel Meridian 1 Description, Installation, And Maintenance page 65

4 Do not define a gateway.
Note: Check the connection using the PC/UNIX ping command
(ping<IP-address>).
Procedure 16
Entering LAN parameters for an MIVS card that connects to customer
network
1 Once the system successfully registers the MIVS keycode, log into the
CLI as root user directory.
2 At the root user directory prompt, enter mivs to access the MIVS
directory.
3 At the SAdmin, SMaint, PAdmin, PMaint, LOgout, ?: prompt, enter sa
to access System Administration.
4 At the SYstem, REcorder, ?: prompt, enter sy to access System
Attributes.
5 Enter the system attributes of the MIVS card, including the IP address,
gateway, and subnet mask. See "CLI System Administration menu" on
page 87 for details.
6 At the Modify, Save, Cancel: prompt, enter s to Save the system
attributes.
7 At the Restart MIVS? prompt, enter Yes.
Note: This step may take a few minutes.
8 From a PC terminal, "ping" the MIVS card to ensure that it has a proper
connection to the LAN. To ping an MIVS card, do the following:
a. Click Start and select Run.
b. In the Open: field, enter ping <IP address>, where <IP address> is
the IP address of the MIVS card.
c. Click OK and observe the DOS window that opens.
If you receive the Reply from <IP address>... message, you have set
up the LAN connection properly and you can proceed. If you receive
the Request timed out. message, there is a problem with the LAN
connection.
9 You must define an agent ID here if you use agent IDs. Refer to the
information contained in Note 2 on page 60.
MIVS Description, Installation, Administration, and Maintenance
Installation and configuration Page 65 of 126