Table of Contents
Advertisement
Note: If your ISP provides directions on how to set up a bridge for IPTV and Internet
service, follow those directions.
Note: This feature is only supported if the router is in router mode.
Set up a bridge for a port group
If the devices that are connected to the router's Ethernet LAN port include an IPTV
device, your ISP might require you to set up a bridge for a port group for the router's
Internet interface.
A bridge with a port group prevents packets that are sent between the IPTV device and
the router's Internet port from being processed through the router's Network Address
Translation (NAT) service.
To configure a port group and enable the bridge:
1. Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2. Enter orbilogin.com.
A login window opens.
3. Enter the Orbi admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced > VLAN / Bridge Settings.
The VLAN / Bridge Settings page displays.
5. Select the Enable VLAN / Bridge Settings check box.
The page expands.
6. Select the By bridge group radio button.
The section expands.
7. Select the Wired Ports check box that corresponds to the Ethernet port on the router
to which the device is connected.
You must select at least one Wired Ports check box. You can select more than one
check box.
8. Click the Apply button.
Your settings are saved.
Specify Network Settings
Orbi Whole Home Tri-Band Mesh WiFi 6 System
76
User Manual
Advertisement
Table of Contents
