Replacing the optical-drive
connector board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Align the screw hole on the optical-drive connector board with the screw hole
on the palm rest and keyboard assembly.
2
Replace the two screws (M2x2) that secure the optical-drive connector board
to the palm rest and keyboard assembly.
3
Connect the optical-drive connector-board cable to the system board.
4
Close the latch that secures the optical-drive connector-board cable to the
system board.
Post-requisites
1
Replace the
base
2
Replace the
optical
computer. After working inside your computer, follow
After working inside your
cover.
drive.
computer. For more safety best
www.dell.com/
Before
39